Set 4 side feed SARD 800cc Fuel injectors.
Side feeds fit straight into the 3sgte fuel rail.
Aftermarket EMS required to contol these large injectors. Learn More

CP Piston kit.

8.5:1 compression ratio calculated with 1.4mm head gasket & 49cc head volume.

86.25mm bore, which allows a good used block to be honed finished for oil clearance.

Supplied with new pins & top quality ring set. Learn More

Cost effective stand alone engine management system, favoured by Japanese sports car tuners across the world. The ECU is simply plug and play for rev3+ cars. Learn More

ARP High quality professional fasteners offer this uprated 3SGTE flywheel bolts kit (set of 8 bolts), suitable with aftermarket or OEM flywheel. Learn More

It is for good reason that virtually every top professional engine builder relies on ARP® Pro Series head studs for their all-out competition powerplants. Simply stated, there’s not a better stud setup on the market today. Learn More

ARP® uses a premium grade 8740 alloy that is rated far superior to “aircraft” quality. Then, each stud is placed vertically in special racks and precisely heat-treated to 190,000 psi. Learn More

EAGLE 4340 FORGED STEEL RODS

Every rod is magnafluxed, X-rayed, and ultrasonic tested to ensure the best quality. Learn More

The addition of a Greddy intercooler is an excellent way of safely increasing horsepower. By reducing the engine's inlet temperatures, a denser air charge will enter the engine this will make more power at the same boost level. Learn More

This boost controller is based on a ball and spring mechanism. A simple turn of a screw is all it takes to lower or raise boost. Instructions enclosed & technical help available via email. We have been successfully retailing & installing this type of manual boost controller since 1999. Learn More